Steel Reinforced Nylon Gear Rack
Gear Rack With Steel Core | Italian Made by Stagnoli.
Nylon gate rack with a steel core for screwing to your sliding gate rail to allow the gate motor to act. Compatible with sliding gate and cantilever gate systems.
The fastening system, "Three Points", on the six rack attachments (in this model, facing upward, opposite the teeth) guarantees a higher capacity than the prior models, up to a maximum of 1200 KG.
The material used is always a polyamide, 30% fibreglass but elastomeric, to guarantee great performance even in very cold environments.
Stagnoli Sliding Gate Rack – S6
Nylon sliding gate rack used for both domestic and commercial sliding and cantilever gate systems. Up to 1200kg with 10×10 steel core to the centre. There are six brackets up mounting lugs with a 25mm gap in-between, allowing for adjustability in case of ground movement over time.
The benefit of brackets up allows a greater reach to the motor gears when the gate's bottom beam is positioned higher than the motor.
The six bracing lugs allow for a higher load capacity on the rack at 1200kg.
Specifications
Application |
Screw on the lengths of the gear rack to enable the sliding gate to move when actuated. |
Material |
Nylon Coated with Steel Core |
Country of Manufacture |
Italy |
Dimensions