Close
Sliding Gate Hardware Kit

3.5m Complete Standard Sliding Gate Hardware Kit

SGK-R78-35

Product Information

68mm Recess Wheels | Sliding Gate Hardware

 



 
  • R10 profile to suit the entire range of APC Galvanized profile tracks
     
  • Dual bearing system for the capacity of 250KG per wheel (500kg per pair)
     
  • Fits into 50mm heigh tubing with a cut-out size to fit the wheel of 70x35mm
     
  • Raises the gate by 30mm when installed with the floor track
     
  • Easy installation with pre-punched fixings, just drops into place after cut out and screws to the tubing from the flanged sides
     

 

 

78mm Flat Mount Wheels

 

  • R10 profile to suit the entire range of APC Galvanized profile tracks

  • Dual bearing system for the capacity of 250KG per wheel (500kg per pair)

  • Fits straight to the bottom, no cut out required

  • Raises the gate by 92mm when installed with the floor track

  • Easy installation with pre-punched fixings, screws to the tubing from each side


    •  

 

 

60mm Nylon Roller and Bracket Set





  • 165mm Long Galvanized steel construction for long life outdoor use

  • 60mm Nylon rollers with completly adjustable positions

  • 75mm internal clearance between rollers at full span, allowing for 25mm ajustment for the gate a gate thickness not exceeding 50mm is ideal (see 200mm long bracket to allow 85mm gate thickness)

  • Pre-punched fixing holes ideal for adjustments prior to final fixing

Bolt Down Galvanized Floor Track

 



 
  • R10 profile to suit the entire range of APC recess and flat mount wheels

  • Rounded profile provides the least resistance for sliding gate movment over the alternative "V groove"

  • High strength 3mm steel, Galvanized for complete long life outdoor use

  • Pre-punched fixing holes ready for anchor nails (Supplied)

  • Easy to install, bolts down to concrete! No need to set in during concreting


    •  

 

55mm U Guide





  • Galvanized steel construction for long life outdoor use

  • Flared entry to guide gate into the reciever in case of wind loads pushing the gate

  • 55mm internal clearance ideal for standard steel or aluminum gates without cladding

  • Pre-punched fixing holes ideal for adjustments prior to final fixing

Anodized Gate Stop

 



 
  • Anodized steel construction for long life outdoor use

  • 115mm Height

  • 40mm Rubber bumper

  • Solid 100x80mm base

  • Pre-punched 10mm fixing holes


    •