3.5m Complete Cladded Sliding Gate Hardware Kit with Z Channel
SGK-R78-35-Z-C
Product Information
68mm Recess Wheels | Sliding Gate Hardware
- R10 profile to suit the entire range of APC Galvanized profile tracks
- Dual bearing system for the capacity of 250KG per wheel (500kg per pair)
- Fits into 50mm heigh tubing with a cut-out size to fit the wheel of 70x35mm
- Raises the gate by 30mm when installed with the floor track
- Easy installation with pre-punched fixings, just drops into place after cut out and screws to the tubing from the flanged sides
78mm Flat Mount Wheels
- R10 profile to suit the entire range of APC Galvanized profile tracks
- Dual bearing system for the capacity of 250KG per wheel (500kg per pair)
- Fits straight to the bottom, no cut out required
- Raises the gate by 92mm when installed with the floor track
- Easy installation with pre-punched fixings, screws to the tubing from each side
Aluminum C Channel & Guide Block Combo
- 400x85x30mm Aluminium C channel System to allow for a full slide of the guide block from static to 325mm
- Incorparates perfectly into the APC Z channel system or a pre-welded angle of 40x40mm on the gate
- Allows for unobstructed guiding from the rear of the gate, ideal for angled gates, spear top gates, cladded gates or just to close to the fence.
- Requires a spacing of 80mm from the rear of the gate to the guide post
- Fix as per requirment, blank canvas without any punchings
- Easy to install, use self drilling screws and fix directly to the guiding post
Aluminum Z Channel For Rear Guiding
- 30x30x4mm thickness Aluminum Z channel System
- Incorparates perfectly into the APC guide block system
- Allows for unobstructed guiding from the rear of the gate, ideal for angled gates, spear top gates, cladded gates or just to keep the gate right up to the fence.
- Fix as per requirment, blank canvas without any punchings
- Easy to install,use self drilling screws and fix directly to the inside face of the gates top tube
Bolt Down Galvanized Floor Track
- R10 profile to suit the entire range of APC recess and flat mount wheels
- Rounded profile provides the least resistance for sliding gate movment over the alternative "V groove"
- High strength 3mm steel, Galvanized for complete long life outdoor use
- Pre-punched fixing holes ready for anchor nails (Supplied)
- Easy to install, bolts down to concrete! No need to set in during concreting
55mm U Guide
- Galvanized steel construction for long life outdoor use
- Flared entry to guide gate into the reciever in case of wind loads pushing the gate
- 55mm internal clearance ideal for standard steel or aluminum gates without cladding
- Pre-punched fixing holes ideal for adjustments prior to final fixing
Anodized Gate Stop
- Anodized steel construction for long life outdoor use
- 115mm Height
- 40mm Rubber bumper
- Solid 100x80mm base
- Pre-punched 10mm fixing holes